For Austria: This offer is aimed at buyers who do not fulfil the conditions for the application of the zero tax rate in accordance with § 28 para. 62 UStG 1994.
For Germany: This offer is aimed at commercial buyers with a system size of over 30KWp. For this, the legislator provides for a VAT rate of 19%.
Private buyers and buyers with system sizes of less than 30KWp are subject to a VAT rate of 0%
Solid design for storm-proof mounting. The components are tested for wind speeds above 200 km/h.
With this high-quality mounting set, 2 photovoltaic modules can be mounted side by side on a tiled roof. The frame of a module may be a maximum of 115 cm wide and 3 cm high. Screws for fastening the roof hooks to the rafters are included. The quantities are calculated for a rafter spacing of 70 cm and a rafter width of 8 cm. In most commercially available sets, a roof hook is mounted on only every second rafter. With this set, however, a roof hook is mounted on every rafter and the mounting rails are continuous, which gives the construction extra security.
This set provides you with a sufficient number of centre clamps and rail connectors to allow you to effortlessly expand your installation with another mounting set for 1 or 2 modules. Benefit from our generous equipment to upgrade your system flexibly and efficiently.
For the installation of the roof hooks, a spacer (e.g. 4 mm piece of wood) is required between the rafters and the roof hooks, depending on the height of the cross battens. Alternatively, a sheet metal replacement tile can be installed.
Spacers and sheet metal replacement tiles are not included in the scope of delivery.
Scope of delivery
- 8x Roof Hook DH02
- 8x Rail Clamp MSK02
- 2x Mounting Rail 110cm MS110
- 6x Rail Connector SV150
- 4x Mid Clamp MK30B
- 4x End Clamp EK30B
- 2x Grounding Plate EP35
- 1x Grounding Clamp EKL01
- 2x Mounting Rail 130cm MS130
- Assembly Instructions DE / EN